DRAKE Datacom DT-103 Manual de instrucciones descargar pdf (Pagina 16)

Change: punch the yellow key, the picture shows:

Light the Satellite tape and punch the OK key to enter the

soft-keyboard interface:

Use the Ʒͩ, +/- key to move the cursor and the OK key

to confirm the input

Use CAPS instruction to switch the letter state between

capital and miniscule

Use NUM instruction to switch the mode from letter to digit

and special symbol

After inputting, move the cursor onto the Save instruction

and punch the OK key to save the installation

Light the TP frequency; punch the +/- key to choose the

appropriate stored transponder parameter of TP frequency,

LNB polarization, Symbol Rate that belong to the

selected satellite or, directly, punch the digit-keys to

complete the value input of TP frequency, LNB polarization,

Symbol Rate

Light the Channel Name menu tape; punch the +/- key to

choose the channel’s name which belong to the choosing

transponder, punch the OK key to appear the

soft-keyboard to rename the channel name which

operation just as above-mentioned about soft-keyboard

introduction. Light the Video PID, Audio PID, and PCR

instruction tape and punch the digit-keys to input the

correct value

Add: return to the Edit Satellite interface and punch the

blue key, the picture shows as:

Punch the OK key to reveal the soft-keyboard to define

the satellite name, finish the definition, input one-group

parameter of TP frequency, LNB polarization and

Symbol Rate, punch the OK key to save the installation

and the new satellite will be added meanwhile. Check the

added satellite in the Select Satellite menu interface pls

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

DRAKE Datacom DT-103 Manual de instrucciones Pagina 16