DRAKE 4000 series II Guía de usuario descargar pdf (Pagina 118)

Panel User Guide Issue 1.4 4000 Digital Series II

Page 88 STA0380

The Direct Access Keys can be programmed with a range of attributes as set in the Configuration and

Master Assignment Programming System (CMAPSi) workstation software. The pushbutton attributes

are:

NOTE: For the above functions, the destination can be a single or group of panels, or a single or group

of external sources.

Table 31: PD4212 DAK Operation

Latch When a DAK is pressed and released, it latches in the

engaged position. Pressing the DAK again disengages it.

Non-Latch When a DAK is pressed and held depressed, it automatically

disengages when released.

Latch/Non-Latch A combination of the two above such that a quick press will

latch the button and a slow press will be the non-latch action.

Dual Talk/Listen When a DAK is momentary pressed, it makes a latched Lis-

ten Route. The DAK can then be pressed and held to make a

Talk Route at the same time, and released to unmake the

Talk Route. A second momentary press disengages the DAK

and the latched Listen Route.

Interlock Group A DAK can be assigned to any one of eight interlock groups

A - H. Within an interlock group only one DAK may be active

at any one time. If a DAK in a given group is pressed whilst

another DAK in the same group is already active the cur-

rently active key is deactivated and the key pressed

becomes active.

Table 32: PD4212 Pushbutton Attributes

Talk Only A single DAK press causes an audio route to be made

from the source panel to the desired destinations. Nor-

mally used for communication from one panel to another.

Listen Only A single DAK press causes an audio route to be made

from the destination. Used when listening to an external

audio signal (not originating from a Control Panel) is

required.

Talk and Listen A single DAK press causes a bi-directional audio route to

be made between the source panel and the destinations.

Used between panels and also with certain external audio

signals.

Talk & Forced

Listen

This is similar to Talk and Listen except that the Listen

route is permanently made. The operator need only press

the DAK to talk.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 235 236

Sin comentarios

DRAKE 4000 series II Guía de usuario Pagina 118