DRAKE 4000 series II Guía de usuario descargar pdf (Pagina 35)

4000 Digital Series II Issue 1.4 Panel User Guide

STA0380 Page 5

The Direct Access Keys can be programmed with a range of attributes as set in the Configuration and

Master Assignment Programming System (CMAPSi) workstation software. The pushbutton attributes

are:

NOTE: For the above functions, the destination can be a single or group of panels and external sources,

conferences or IFBs.

3.2.3 Talk Tally LED

This Red LED indicates that the button action is active (either latched or transient), dependent on

individual programming/assignment. This LED will flash when the destination is busy if this feature is

enabled.

3.2.4 Listen Tally LED

This Green LED indicates that an audio is being received by the Control Panel from the source

associated with the DAK.

3.2.5 PD4215R Direct Access Key Indicator LED

The tri-coloured LEDs associated with the Direct Access Keys (DAKs) have the following meanings:

• Red (R) means “Talk” (key pressed).

• Green (G) means “Listen” (incoming audio from that source).

• Orange (O) means activity (a mix of Talk and Listen).

Interlock Group A DAK can be assigned to any one of eight interlock

groups A - H. Within an interlock group only one DAK

may be active at any one time. If a DAK in a given group

is pressed whilst another DAK in the same group is

already active the currently active key is deactivated and

the key pressed becomes active.

Table 2: PD4215R Pushbutton Attributes

Talk Only A single DAK press causes an audio route to be made

from the source panel to the desired destinations. Nor-

mally used for communication from one panel to another.

Listen Only A single DAK press causes an audio route to be made

from the destination. Used when listening to an external

audio signal (not originating from a Control Panel) is

required.

Talk and Auto Listen A single DAK press causes a bi-directional audio route to

be made between the source panel and the destinations.

Often used between panels and external audio signals.

Talk & Forced Listen This is similar to Talk and Auto Listen except that the Lis-

ten route is permanently made. The operator need only

push the key to talk.

Table 1: PD4215R DAK Operation

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 235 236

Sin comentarios

DRAKE 4000 series II Guía de usuario Pagina 35